Page 3 of 3

Re: External Controls Help

Unread postPosted: Thu Jul 12, 2012 12:51 pm
by jagiar
I don't mean to hijack the thread but this one seems the most appropriate as it's the same theme.

I wish to use xnsw to measure the time it takes for a user to react to a signal (the signal would be the 'start' control) and place a ball at a certain point (using the laser and a photoresistor as the finish line of the ball (and hence the 'stop' control). Is this possible with xnsw? It seems like there is no way to seperate the start/stop control on the external controls option.

Re: External Controls Help

Unread postPosted: Sun Jul 15, 2012 7:07 pm
by Stopwatch
jagiar wrote:It seems like there is no way to seperate the start/stop control on the external controls option.

Yes it's not possible yet. However you may connect two pair of wires in parallel.