Page 3 of 3
Re: photo finish setup
Posted:
Sun Aug 03, 2014 6:40 pm
by Stopwatch
robertcoach wrote:Do you know what else I can do?
Find a programmer who could debug camstudio.
Re: photo finish setup
Posted:
Wed Aug 20, 2014 2:52 pm
by robertcoach
Hi
In the version you post on page one
Try this.
Attachments xnsw.zip(223 KiB) Downloaded 21 times
The port doesn't work as well as the 1.68 version but the stamp in Canstudio in 1.68 doesn't work like that version you post.
Can you fix that?.
Re: photo finish setup
Posted:
Thu Aug 21, 2014 9:25 am
by Stopwatch
robertcoach wrote:Can you fix that?.
- xnsw.zip
- (207.12 KiB) Downloaded 2724 times
Re: photo finish setup
Posted:
Thu Aug 21, 2014 3:52 pm
by robertcoach
Yes very good.
Re: photo finish setup
Posted:
Thu Aug 21, 2014 4:07 pm
by robertcoach
Hi
Will it be possible to have automatic reset? Every time the gun goes the stopwatch is starting from zero.
I notice that with DTR-DSR the stopwatch reset when the contact is on and start when the contact is off. It will be perfect if the stopwatch can reset and start when the contact is on and nothing happen when the contact is off. With RTS-CTS the stopwatch start when the contact is on and noting happen when the contact is off but we have to reset first. Many error happen because the stopwatch is not reset prior the gun start most of the time in the situation of fall start, someone forgot to reset first. That will be so good, we could eliminate manual timing people to start the race in case the stopwatch is not reset.
Thank again for your support, it’s really appreciated
Re: photo finish setup
Posted:
Fri Aug 22, 2014 2:04 am
by robertcoach
Hi
Hi, just to be clear, the idea is to never stop the stopwatch, we use the snap to have the time and the gun start reset and start from zero from the first contact.
Merci
Re: photo finish setup
Posted:
Fri Aug 22, 2014 1:25 pm
by Stopwatch
robertcoach wrote:Will it be possible to have automatic reset?
Sorry, no. Try to exploit special pins.
viewtopic.php?f=3&t=433#p549
Re: photo finish setup
Posted:
Fri Aug 22, 2014 6:46 pm
by robertcoach
Hi
viewtopic.php?f=3&t=433#p549
In this topic, they use the same switch to start stop and reset, what I would like is to never has to stop the stopwatch, it will be as the gun goes that the stopwatch reset and keep running from zero.
Anyway to do that?
Re: photo finish setup
Posted:
Sat Aug 23, 2014 8:49 am
by Stopwatch
robertcoach wrote:In this topic, they use the same switch to start stop and reset,
Read about pins only. That's all that I can do.
Re: photo finish setup
Posted:
Sun Aug 24, 2014 10:50 pm
by robertcoach
Hi
With Com0Com and Hub4com when I connect the gun with DRS-DTR, I'm close to have what I need. At the first contact of the switch of the gun I have the flash and the noise as xnote rest to zero. When the switch is off, xnote start. The problem is the switch is not consistent so I cannot just calculate a delay in the final time. If xnote could reset and start at the first contact that will be perfect. I cant fine the pin out to do just that.