Spreadheet output for each start and stop
Posted: Fri Jan 14, 2011 9:37 pm
I have normally open contacts on my HVAC controller board, wired to pins 7/8 on a DB9 connector. Compressor turns on, contacts close and the XNote timer starts incrementing. Compressor turns off, contacts open and the XNote timer stops incrementing. So far so good!
Problem is, how can I get spreadsheet entries "Without" the snap feature? There is no way to "snap" on and "snap" off. I need to graph the time on, time off and correlate to interior and exterior temp data as well as power usage.
Any help is greatly appreciated. If we can make this work, I will GLADLY pay for the software. The XNote software is really useful and the gears are turning already.
Thanks,
John
Problem is, how can I get spreadsheet entries "Without" the snap feature? There is no way to "snap" on and "snap" off. I need to graph the time on, time off and correlate to interior and exterior temp data as well as power usage.
Any help is greatly appreciated. If we can make this work, I will GLADLY pay for the software. The XNote software is really useful and the gears are turning already.
Thanks,
John