MG wrote:Are you aware of a simple interface to which I can connect the photocells to the computer?
JanHgm wrote:You need to connect your photocells to an Opto coupler to create a switch. That switch is connected to Start/Stop or Snap wires on RS232
(I believe I put some description how to do this on my Camstudio4Xnote site)
This way you can compare your sensors with a regular Red or IR light beamer that I'm using
You want to use the first beamer to start Xnote. (RS232 - Start/Stop, with a huge Skip contact bounce )
Second, Third, etc beam to set a pass time (RS232 - Snap)
Finally, last sensor to stop recording. (RS232 - Start/Stop)
Connect all the cables and connect them to RS232
Users browsing this forum: No registered users and 301 guests